art. nr. 05K77  50ml

• Vidutinio stiprumo,  skirtas tiesiems ir smailėjantiems vamzdžių sriegiams.
• Max. fiks.diametras: M 80/R3’’
• Max užpildo 0.35mm tarpa
• Sujungimas naudojamas po 10 - 20 min.
• Atsparus temperatūrai: -55 °C iki +150 °C
• Nenauduoti plastmasiniams sujungimams ir vamzdžiams, taipat deguones irenginiams ir vamzdžiams su stipriom oksiduojančiom rūgštym.
• Puiki alternativa Loctite 577

The product seals conical/ cylindrical pipe thread connections up to R 3“, e.g. sprinkler installations and gas pipeline systems. Firmly tightened screw connections are immediately sealed against pressures of up to 5 bar. Curing takes place even at low temperatures (< 0°C). Resolvable with tools.    Not authorized for domestic gas installations according to TRGI 86/96

Chemical characteristics:  Methylacrylat anaerobic resin;  Colour: Yellow ; Viscosity:20.000 – 40.000 mPas; Specific gravity:     1.05 – 1.09 g/ml;  Max. gap filling: 0,35 mm; Max. clearance: M 80 

Physical Properties: Handling cure time:   10 – 20 minutes Functional time:     3 – 6 hours Full cure time:    12 – 24 hours Breakaway torque:   20 – 30 Nm      Prevailing torque:    20 – 30 Nm    Temperature range:   - 55°C up to + 150°C

Instruction of use: This product is not suitable for metal-plastic couplings and oxygen facilities as well as for the sealing of basic products or systems with strong oxidizing acids. Use only on standard metal threads. Surface must be clean and free of grease. For this, use the degreaser product WIKO Industrial Fast Cleaner. Apply product to fill the gap completely (male and female parts), assemble parts and shut completely. A bland or superficial closure may cause leakage over time. Don’t move after tightening. Before operating the system to wait 24 hours to allow complete curing time. In the case of serial products, locking the joint with a pipe wrench to avoid breaking the previous film in its formative stages. In case of passive surfaces and/or low temperature a fast cure can be obtained using WIKO Activator Anaerobic. Consult the MSDS before use. By usage of an activator the curing values may drop by 15%.  .